Suzuki Liana RH413, Service Manual

Page: 671 / 1302

Automatic Transmission/Transaxle: 5A-123
• Apply A/T fluid to forward clutch separator plates (1),
discs (2) and retaining plate (3).
• Install forward clutch separator plates (1), discs (2)
and retaining plate (3), then snap ring (4) to forward
clutch drum.
• Install forward clutch plate snap ring so that its both
ends would be positioned in correct locations as
shown in the figure.
• Measure forward clutch piston stroke in the same
manner as “Forward and Reverse Clutch Assembly
Preliminary Check”.
When piston stroke is out of specification, select
forward clutch retaining plate with proper thickness
from among the following table and replace it.
Special tool
(A): 09900–20607
(B): 09900–20701
(C): 09952–06020
Forward clutch piston stroke
1.30 – 1.50 mm (0.051 – 0.059 in.)
Available forward clutch retaining plate thickness
• Apply A/T fluid to reverse clutch separator plate (1)
discs (2) and retaining plate (3).
• Install cushion plate (1), reverse clutch separator plate
(1) discs (2) retaining plate (3) and then snap ring (6)
to intermediate shaft subassembly. Clutch retaining
plate (Th = 2.3 mm) (2), discs (3), separator plate (Th
= 1.8 mm) (4) and retaining plate (5).
• Install reverse clutch plate snap ring so that its both
ends would be positioned in correct locations as
shown in the figure.
[A]: Correct
[B]: Incorrect
I2RH0B510180-01
I2RH0B510187-01
I2RH0B510188-01
Thickness Identification mark
3.0 mm (0.118 in.) 1
3.1 mm (0.122 in.) 5
3.2 mm (0.126 in.) 2
3.3 mm (0.130 in.) 6
3.4 mm (0.134 in.) 3
3.5 mm (0.138 in.) 7
3.6 mm (0.142 in.) 4
I3RH0A510031-01
I3RH0A510032-01