Suzuki Liana RH413, Service Manual

Page: 345 / 1302

Front Suspension: 2B-3
Adjustment
1) Loosen right and left tie-rod end lock nuts (1) first.
2) Rotate right and left tie-rods (2) by the same amount
to align toe to specification. In this adjustment, right
and left tie-rods (2) should become equal in length
“A”.
NOTE
Before rotating tie-rods (2), apply grease
between tie-rods and rack boots so that
boots won’t be twisted.
3) After adjustment, tighten lock nuts (1) to specified
torque.
Tightening torque
Tie-rod end lock nut (a): 45 N·m (4.5 kgf-m, 32.5 lb-
ft)
NOTE
Make sure that rack boots are not twisted.
Steering Angle Check and Adjustment
When tie-rod or tie-rod end was replaced, check toe and
then also steering angle with turning radius gauge (1).
If steering angle is not correct, check if right and left tie-
rods are equal in length “A”.
NOTE
If tie-rod lengths were changed to adjust
steering angle, reinspect toe-in.
Steering angle
Inside: 37.5
° ±
3
°
Outside: 32.5
° ±
3
°
Reference Information
Side slip
When checked with side slip tester, side slip should
satisfy following specification.
Side slip
IN 1.0 to IN 4.0 mm/m (IN 0.039 to IN 0.157 in/3.3 ft)
If side slip exceeds the limit, toe or front wheel alignment
may not be correct.
I3RH0A220002-01
I3RH0A220003-01