Suzuki Liana RH413, Service Manual

Page: 1021 / 1302

Air Bag System: 8B-96
NOTE
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components, ensure all components are properly mounted.
• Clear diagnostic trouble codes (Refer to “DTC Clearance”), if any.
• Repeat “Air Bag Diagnostic System Check” to confirm that the trouble has been corrected.
Repair Instructions
Disabling Air Bag System
S3RH0A8206001
1) Turn steering wheel so that vehicle’s wheels (front
tires) and pointing straight ahead.
2) Disconnect negative (–) cable at battery.
3) Turn ignition switch to “LOCK” position and remove
key.
4) Remove “AIR BAG” fuse (2) from fuse box (1).
5) Disconnect yellow connector (3) of contact coil and
combination switch assembly as follows.
a) Release locking of lock slider (5).
b) After unlocked, disconnect connector.
6) In case of passenger air bag (inflator) module, pull
out glove box while pushing its stopper from both
right and left sides and disconnect yellow connector
(4) of passenger air bag (inflator) module as follows.
a) Release locking of lock slider (5).
b) After unlocked, disconnect connector.
3 1) With ignition switch OFF, disconnect Special Tool (B)
and (C) then reconnect contact connector “L73” or “L74”.
2) Disconnect side air bag (inflator) module connector (1)
from side air bag (inflator) module.
3) Check proper connection to side air bag (inflator)
module at terminal in connector.
4) If OK, then connect Special Tool (A), (B) and (C) to
connector.
Special tool
(A): 09932–76010
(B): 09932–75010
(C): 09932–78310
With ignition switch ON, does DTC B1084 or B1088 still
exist?
DTC: B1084
Repair short from
“WHT/RED” or “WHT/
GRN” wire circuit to
power circuit.
DTC: B1088
Repair short from “RED/
BLK” or “RED/YEL” wire
circuit to power circuit. Replace side air bag
(inflator) module
referring to “Side Air
Bag (Inflator) Module
Removal and
Installation”.
Step Action Yes No
1
(A)
(B)
(C)
STEERING WHEEL
“L75”, “L76”
I3RH0A820089-01