Suzuki Liana RH413, Service Manual

Page: 501 / 1302

Parking Brake: 4D-2
Repair Instructions
Parking Brake Inspection and Adjustment
S3RH0A4406001
Inspection
Hold center of parking brake lever grip and pull it up with
200 N (20 kg, 44 lbs) force.
With parking brake lever pulled up as shown, count
ratchet notches. There should be 6 to 8 notches.
Also, check if both right and left rear wheels are locked
firmly.
To count number of notches easily, listen to click sounds
that ratchet makes while pulling parking brake lever
without pressing its button.
One click sound corresponds to one notch.
If number of notches is out of specification, adjust cable
referring to adjustment procedure so as to obtain
specified parking brake stroke.
NOTE
Check tooth tip of each notch for damage or
wear.
If any damage or wear is found, replace
parking brake lever.
Adjustment
NOTE
Make sure for the following conditions before
cable adjustment.
• No air is trapped in brake system.
• Brake pedal travel is proper.
• Brake pedal has been depressed a few
times with about 300 N (30 kg, 66 lbs) load.
• Parking brake lever (1) has been pulled up
a few times with about 200 N (20 kg, 44 lbs)
load.
If parking brake cable is replaced with new
one, pull up parking brake lever a few
times with about 500 N
⋅
m (50 kg, 110 lbs)
force.
• Rear brake shoes are not worn beyond
limit, and self adjusting mechanism
operates properly.
After confirming that the conditions are all satisfied,
adjust parking brake lever stroke by loosening or
tightening adjust nut (3).
NOTE
Check brake drum for dragging after
adjustment.
Parking brake stroke (When lever is pulled up at 200
N (20 kg, 44 lbs)
6 – 8 notches
Parking Brake Cable Removal and Installation
S3RH0A4406002
Removal
NOTE
When it is necessary to remove both right
and left parking brake cables, repeat below
steps 2) and 6) on right and left wheels.
1) Raise, suitably support vehicle.
2) Remove wheel.
3) Disconnect parking brake cable from equalizer
(parking brake lever) and clamps.
4) Remove brake drum. Refer to “Rear Brake Drum
Removal and Installation in Section 4C”.
5) Disconnect parking brake cable from brake shoe
lever referring to “Rear Brake Shoe Removal and
Installation in Section 4C”.
6) Remove parking brake cable and parking brake
cable bracket.
I2RH01440001-01
2. Brake cable
I2RH01440002-01