Suzuki Liana RH413, Service Manual

Page: 489 / 1302

Front Brakes: 4B-5
4) Remove piston seal using a thin blade like a
thickness gauge, etc.
CAUTION
!
Be careful not to damage inside (bore side) of
cylinder.
5) Remove bleeder plug and cap from caliper.
Assembly
Assemble parts in reverse order of disassembly,
observing the following instructions.
CAUTION
!
• Wash each part cleanly before installation
in the same fluid as the one used in master
cylinder reservoir.
• Never use other fluid or thinner.
• Before installing piston seal or cylinder
boot to cylinder, apply brake fluid to them.
• Install a new piston seal into groove in
cylinder securely making sure that it is not
twisted.
• Before installing caliper to carrier, install
slide pin with grease applied into caliper
carrier hole and check for its smooth
movement in thrust direction.
• After reassembling brake lines, bleed air
from them.
• Install piston seal, boot, piston and retaining ring to
caliper referring to the following instructions.
1) Replace with a new piston seal (1) at every overhaul.
After applying grease, fit piston seal (1) into groove
in cylinder taking care not to twist it.
2) Before inserting piston (2) into cylinder, apply grease
to new boot (1) and install it onto piston as shown.
3) Fit boot as it is in figure into boot groove in cylinder
with fingers.
I2RH01420013-01
I2RH01420016-01
“A”: 1 grooved side directed cylinder side
“B”: 2 grooved side directed pad side
1
I2RH01420017-01
I2RH01420018-01
I2RH01420019-01