Suzuki Liana RH413, Service Manual

Page: 705 / 1302

Automatic Transmission/Transaxle: 5A-157
• Install torque converter aligning grooves (1) of
torque converter and projection (2) of oil pump
drive gear.
• Install torque converter, using care not to damage
oil seal of oil pump.
• After installing torque converter, check that
distance “a” is within specification.
Torque converter installing position
“a”: More than 19.9 mm (0.783 in.)
• Check torque converter for smooth rotation.
• Apply grease around cup (6) at the center of
torque converter.
“C”: Grease 99000–25010
Specifications
Tightening Torque Specifications
S3RH0A5107001
4. Flange nut
5. Torque converter housing
I2RH0B510337-01
Fastening part
Tightening torque
Note
N
⋅
m kgf-m lb-ft
A/T fluid drain plug 17 1.7 12.5 ) / ) / )
Transmission range sensor bolt 5.5 0.55 4.0 ) / )
Output shaft speed sensor / VSS bolt 13 1.3 9.5 ) / )
Input shaft speed sensor bolt 5.5 0.55 4.0 ) / )
Valve body harness connector bolt 5.5 0.55 4.0 ) / )
Shift solenoid bolt 11 1.1 8.0 )
Oil strainer bolt 10 1.0 7.5 ) / )
Oil pan bolt 7.0 0.7 5.0 ) / )
Transaxle and engine fastening bolt and nut 85 8.5 61.5 )
Drive plate to torque converter bolt 25 2.5 18.0 )
Steering knuckle ball stud lock nut 60 6.0 43.5 )
Exhaust No.1 pipe to manifold bolt 50 5.0 36.5 )
Exhaust No.2 pipe to No.1 pipe bolt 43 4.3 31.5 )
Engine front mounting nut 45 4.5 32.5 )
Engine rear mounting nut 45 4.5 32.5 )
Mounting member bolt 55 5.5 40.0 )
Suspension frame bolt 90 9.0 65.0 )
Engine rear mounting No.2 bracket M10 bolt 55 5.5 40.0 )
Engine rear mounting No.2 bracket M8 bolt 25 2.5 18.0 )
Engine LH mounting No.1 bolt 55 5.5 40.0 )
Engine LH mounting No.2 bolt 55 5.5 40.0 )
Lower stiffener bolt 50 5.0 36.5 )
Ground cable bolt 23 2.3 17.0 )