Suzuki Liana RH413, Service Manual

Page: 631 / 1302

Automatic Transmission/Transaxle: 5A-83
3) Release lock plate (1) which restrict moving of cable
end holder (2).
4) Push cable end holder (1) out from eye-end (2) using
an appropriate tool (3) to disengage cable.
5) Shift selector lever to “N” position.
6) Apply grease to selector lever pin and install adjuster
(cable end) to it.
: Grease 99000–25010
7) With both selector lever and transmission range
sensor kept each “N” position, drive cable end holder
(1) in until it locks cable.
8) Slide lock plate (2) to secure cable end holder in
position.
9) After select cable was installed, check for the
following.
• Push vehicle with selector lever shifted to “P”
range. Vehicle should not move.
• Vehicle can not be driven in “N” range.
• Vehicle can be driven in “D”, “2” and “L” ranges.
• Vehicle can be backed in “R” range.
Transmission Range Sensor (Shift Switch)
Inspection and Adjustment
S3RH0A5106008
Inspection
1) Disconnect transmission range sensor connector
(1).
2) Check that continuity exists at terminals shown in the
following figure by moving selector lever.
Adjustment
1) Shift manual select lever (4) to “N” range.
2) Check that needle direction shaped on lock washer
(2) and “N” reference line (1) on transmission range
sensor are aligned. If not, loosen sensor bolts (3)
and align them.
Tightening torque
Transmission range sensor bolt (a): 5.5 N·m (
0.55 kgf-m, 4.0 lb-ft)
I2RH01510046-01
I2RH01510047-01
I2RH01510048-01
1
P
R
N
D
2
L
Terminal No.
Sensor P
osition
2 3 4 5 6 7 8 9
1
I3RH0A510037-01
1
3, (a)
4
2
I2RH0B510041-01