Suzuki Liana RH413, Service Manual

Page: 381 / 1302

Rear Suspension: 2C-17
5) Remove wheel sensor ring (if equipped with ABS).
Refer to “Rear Wheel Speed Sensor Ring Removal
and Installation in Section 4E”.
6) Remove hub bolts. Refer to “Front Wheel Hub and
Steering Knuckle Disassembly and Assembly in
Section 2B”.
Installation
1) Install hub bolts.
Refer to “Front Wheel Hub and Steering Knuckle
Removal and Installation in Section 2B”.
2) Install wheel hub (1) and new spindle nut.
3) Tighten spindle nut (2) to specified torque.
NOTE
Removed spindle nut should be replaced
with new one.
Tightening torque
Rear spindle nut (a): 175 N·m (17.5 kgf-m, 126.5
lb-ft)
4) Caulk spindle nut (1) as shown.
WARNING
!
Be careful while calking nut so that no crack
will occur in calked part of nut. Cracked nut
must be replaced with new one.
5) Install new spindle cap.
NOTE
When installing spindle cap, hammer lightly
several locations on the collar of cap until
collar comes closely into contact with wheel
hub.
6) Install brake drum and wheel. For details, refer to
“Rear Brake Drum Removal and Installation in
Section 4C”.
Wheel Hub, Wheel Stud / Wheel Bearing
Outside Inner Race Removal and Installation
(4WD Model)
S3RH0A2306019
CAUTION
!
When wheel hub is removed, replace wheel
bearing set (outer race, bearings and inner
races) and wheel bearing oil seal with new
one.
Removal
1) Hoist vehicle and remove wheel.
2) Remove spindle cap by hammering lightly at 3
locations around it so as not to deform or cause
damage to seating part of cap.
3) Uncaulk drive shaft nut (1).
4) Pull up parking brake lever fully and remove drive
shaft nut (1).
2. Caulk
I2RH01230045-01
I2RH01230046-01
I3RH01232009-01