Suzuki Liana RH413, Service Manual

Page: 229 / 1302

Engine Mechanical: 1D-24
6) Remove tappets (2) with shims (1).
Installation
1) Install tappets and shims to cylinder head.
Apply engine oil around tappet and then install it to
cylinder head.
NOTE
When installing shim, make sure to direct
shim No. side toward tappet.
2) Install camshafts (1).
Apply engine oil to sliding surface of each camshaft
and camshaft journal then install them as shown in
the figure.
NOTE
Before installing camshafts, turn crankshaft
until key position faces upward.
Refer to “Timing Chain and Chain Tensioner
Removal and Installation”.
3) Install camshaft housing pins (1) as shown in the
figure.
4) Check position of camshaft housings.
Embossed marks are provided on each camshaft
housing, indicating position and direction for
installation. Install housings as indicated by these
marks.
5) After applying engine oil to housing bolts, tighten
them temporarily first. Then tighten them by the
following numerical order in the figure. Tighten a little
at a time and evenly among bolts and repeat
tightening sequence two or three times before they
are tightened to specified torque.
Tightening torque
Camshaft housing bolt (a): Tighten 11 N
⋅
m (1.1
kgf-m, 8.0 lb-ft) by the specified procedure
I2RH0B140074-01
I2RH0B140075-01
I2RH0B140076-01
A: I: Intake side or E: Exhaust side C: Pointing to timing chain side
B: Position from timing chain side
I2RH0B140077-01
I2RH0B140078-01
I2RH0B140079-01