Suzuki Liana RH413, Service Manual

Page: 784 / 1302

6B-5 Steering Wheel and Column:
5) Tighten steering shaft nut (1) to specified torque.
Tightening torque
Steering shaft nut (a): 33 N·m (3.3 kgf-m, 24.0 lb-
ft)
NOTE
After installing the steering wheel, turn the
steering wheel about 1 full rotation so that
the cancel cam pin fits into the pin hole in the
steering wheel and then check the turn signal
lever for proper function.
6) Connect audio control switch connector to audio
control switch, if necessary.
7) Install driver air bag (inflator) module to steering
wheel. Refer to “Driver Air Bag (Inflator) Module
Removal and Installation in Section 8B”.
Contact Coil and Combination Switch Assembly
Removal and Installation
S3RH0A6206002
CAUTION
!
Do not turn contact coil (on combination
switch) more than allowable number of turns
(about two and a quarter turns from the
center position clockwise or
counterclockwise respectively), or coil will
break.
Removal
1) Remove steering wheel from steering column
referring to “Steering Wheel Removal and
Installation”.
2) Remove steering column hole cover (1).
3) Remove steering column cover screws (1).
4) Separate upper cover (2) and lower cover (3), then
remove them.
5) Remove contact coil and combination switch
assembly screws (1) and disconnect connectors (2)
from combination switch (3).
6) Disconnect horn connector and air bag connector (1)
from instrument panel harness.
7) Remove contact coil and combination switch
assembly from steering column.
I2RH01620012-01
1
I3RH0A620005-01
1
3
1
2
I2RH01620016-01
2
1
1
2
3
I2RH01620017-01
1
I3RH0A620006-01