ML620Q503/Q504 User's Manual
Chapter 6 Clock Generation Circuit
FEUL620Q504
6–12
6.3 Description of Operation
6.3.1 Low-Speed Clock
6.3.1.1
Low-Speed Built-In RC Oscillation Mode
Figure 6-3 shows the low-speed clock generation circuit configuration in the built-in RC oscillation mode.
When the RC oscillation clock is counted to 128, the low-speed oscillation clock (LSCLK) starts to be supplied.
Figure 6-3 Circuit Configuration in the low-speed Built-in RC Oscillation Mode
6.3.1.2
Low-Speed Crystal Oscillation Mode
Figure 6-4 shows the low-speed clock generation circuit configuration in the crystal oscillation mode.
The low-speed clock generation circuit is provided with an external 32.768 kHz crystal. To match the oscillation
frequency by using a trimmer capacitor, connect external capacitors (C
GL
and C
DL
) as required.
Figure 6-4 Circuit Configuration of the Crystal Oscillation Mode
[Note]
•Install the crystal oscillator near LSI as much as possible, and do not place a signal and power supply wiring
that it becomes a noise source near the crystal oscillator and the wiring.
•The impedance between XT1 and XT0 might decrease by moisture uptake of circuit board in high moisture
environment and condensation on the circuit board, and then the oscillation trouble may occur. Please make
moisture measures such as coating the circuit board when used in such environments. The oscillation stop
might be caused due to condensation.
STOP mode
LSCLK(low-speed oscillation clock)
V
DDL
RC oscillator
circuits
128 counts
PXT0
V
SS
C
DL
C
GL
32.768kHz
Crystal oscillator
PXT1
V
DDL
STOP mode
Low-speed
clock (LSCLK)
R
F
Control circuits
8192 counts
Summary of Contents for LAPIS SEMICONDUCTOR ML620Q503
