Cabletron Systems Netlink FRX8000, User Manual

Page: 44 / 468

4-4 FRX8000 3. 0 User G uide, Rev 02
Network Default Parameters
Explanations of the parameters follow the table. Note that pressing [Enter] in response
to a prompt selects the default value.
1 Will be ignored if the protocol is not used in the network.
2 The defaults for the timeout parameters are the minimum values recommended by X.25.
Specifying a lower value will generate a cautionary message.
3 The sum of values for groups 1–3 should be less than or equal to 100.
Table 4-1 Network Default Parameters
Parameter Valid Values Default Value
Network Name
0–20 characters
NETLI NK
ELP Page Si ze ( lines ) 10–99 62
Output Leading 0s on ELP Y/N N
Cal l Actg Seg. Si ze (
10ths/hr
) 0–255 0
Cal l Actg Seg. Si ze 1–4096 128
DNIC 0–9999 0000
Line Disconnect Timeout ( sec ) 0–254 1
Modem Disconnect Timeout (
sec
) 0–255 0 (
disabled
)
IP Network Address
valid IP address
192.0.0.0
1
IPX WAN Network Address 1–fffffffe 00000001
1
X.25/X.75 Parameters
DCE Restart Timeout ( sec )
5–360 60
2
DCE Incoming Call TO (
sec
) 5–360 180
2
DCE Reset Timeout (
sec
) 5–360 60
2
DCE Clear Ti meout (
sec
) 5–360 60
2
DTE Restart Tim eout (
sec
) 5–360 60
2
DTE I ncoming Cal l TO (
sec
) 5–360 180
2
DTE Reset Tim eout (
sec
)
5–360 60
2
DTE Clear Ti meout (
sec
)
5–360 60
2
DTE Clear Re-xmit Count 0–10 0
DTE Reset Re-xmit Count 0–10 0
DTE Restart Re-xmit Count 0–10 0
X.25 Database Defaults
Defaul t Low SVC LCN 1–4095 10
Defaul t Packet Si ze (
bytes
)
16–4096 128
Modul us
8 or 128
8
Defaul t Window Size (
packets
)
1–7 2
Incoming Address Check Y/N N
Bandwidth Configuration Parameters
Pct of Bandw . – G rp (1–3) 1–100 1 3
Pr iority for Group (1–3) 0–9 0