Cabletron Systems Netlink FRX8000, User Manual

Page: 355 / 468

Alarms 21-33
230.
V25bis, Node “n” LP “n” Port “n” Modem Failed - Cause “n”
Severity: 2
Meaning: Cause Description
1
Disable
2
RFS (CTS) went down
3
Mode switched from LAPB to V.25
4
Call setup failed
5
No response from modem
Action: The appropriate action depends on the cause.
231.
V25bis, Node “n” LP “n” Port “n” Out of Order (CFI DT)
Severity: 3
Meaning: The modem on port “n” tried to dial, but failed, returning a CFI (call
failed indication) and DT (dial tone).
Action: The appropriate action depends on the clearing cause.
232.
V25bis, Node “n” LP “n” Port “n” ATL “n” Dial Out Failed
Severity: 4
Meaning: A dial request was sent by the subscriber, but no dialout occurred.
Action: Check the port/modem connection.
233.
LP “n” Port “n” LCN “n” – No response to RESET (state d2)
Severity: 3
Meaning: A Reset sent by this port has not received a response.
Action: Investigate the other end of the connection for problems.
242.
LP “n” Port “n” LCN “n” – No response to CLEAR (state p6)
Severity: 3
Meaning: A Clear Request sent by this DTE port has not received a response,
and the retry count has expired.
Action: Investigate the other end of the connection for problems.
243.
LP “n” Port “n” – No response to RESTART (state r2)
Severity: 2
Meaning: A Restart Request sent from this port did not receive a response.
Action: Investigate the other end of the connection for problems.
245.
NMP support task at Node “n” failed
Severity: 3
Meaning: The NMP support task did not respond to a watchdog timer request,
and node “n” or its NMP (if a node with attached NMP) is down.
Action: Restart the node/NMP that did not respond.