Cabletron Systems Netlink FRX8000, User Manual

Page: 340 / 468

21-18 FRX8000 3. 0 User G uide, Rev 02
Meaning: Self-explanatory. The values for parameters
“x”–“y”
in the node's
Network Defaults file are changed to the values shown.
113.
Alternate Node changed to “n” on Node “n”
Severity: 4
Meaning: The Alternate NMP Node has been changed to the first “n” in the
Node record for the second “n.”
114.
PVC from (Subscriber ID) - (LCN) to (Subscriber ID) - (LCN) disconnected
Severity: 4
Meaning: Self-explanatory.
115.
PVC connection failure from (Subscriber ID) - (LCN) to (Subscriber ID) - (LCN)
Severity: 3
Meaning: The PVC could not be connected for one of these reasons:
If “
n
”=
1
or
11
:
The PVC request from the local
(1
) or remote (
11
) end was bad.
Either the channel requested was
0
or the specified
LP/port was invalid because one or both were not operational.
If “
n
” =
2
or
12
:
The PVC already exists at the local (
2
) or remote (
12
) end with the
same LP/port and LCN as those requested. The existing
PVC must be removed before it can be recreated.
Action: Self-explanatory, as described in the meaning.
116.
PVC primary setup failure from (Subscriber ID) - (LCN) to (Subscriber ID) -(LCN)
Severity: 3
Meaning: There is a problem with the connection from the first subscriber that
was configured in a particular PVC Connection record. Usually this
means that the subscriber's port is not configured, or that the LP is
either not configured correctly or is not installed.
Action: Check the configuration records for the LP and port specified in the
Subscriber record. If these are all right, check the hardware config-
uration.
117.
PVC secondary setup failure from (Subscriber ID) - (LCN) to (Subscriber ID) (LCN)
Severity: 3
Meaning: There is a problem with the connection from the second subscriber
that was configured in a particular PVC Connection record. Usually
this means that the subscriber's port is not configured, or that the LP
is either not configured correctly or is not installed.
Action: Check the configuration records for the LP and port specified in
the Subscriber record. If these are all right, check the hardware
configuration.