Cabletron Systems Netlink FRX8000, User Manual

Page: 102 / 468

7-22 FRX8000 3. 0 User G uide, Rev 02
Creating/Deleting a PVC On Line
You can create a temporary PVC, then delete it later. (Deleting a PVC will break the
connection, but the LCN will remain dedicated to the PVC until the next IPL of the
node.)
1. Press [D] at the Operations Menu (or [B], [D] from the Main Menu).
2. When prompted, enter:
◆
PVC Type : 7 .
◆
Any other requested information, noting the values in Table 7-5 .
3. When prompted, press [C] to create a connection or [D] to delete a connection.
If the operation is successful, PVC Created/Removed will be displayed.
If a “create” fails, you will see: Can't use same channel or Create rejected, reason “n,”
where:
●
If “ n ” = 1 or 11 , the request from the logical ( 1 ) or physical ( 11 ) end was bad.
Either the channel requested was 0 or the LP/port was not operational.
●
If “ n ” = 2 or 12 , the PVC already exists at the logical ( 2 ) or physical ( 12 ) end.
If a “delete” fails, you will see: Remove rejected, reason “n,” where:
●
If “ n ” = 3 , logical port does not exist.
●
If “ n ” = 4 , node number is incorrect.
●
If “ n ” = 5 , LP/port is incorrect.
When finished with these operations, press any key to return to the Subscriber ID:
prompt, then press [F3] to return to the Operations Menu.