11-2
FRX8000 3. 0 User G uide, Rev 02
Required and Optional Configuration
To run SNA on a port in an FRX8000 Switch or N7400/7500, make sure the following
are correctly configured in the database:
●
Network Defaults
, described in Chapter 4. This file must be configured for a
new network. After that, no further changes are generally necessary.
●
Node parameters
, described in Chapter 5. A record must exist for every
FRX8000, N7400, and N7500 on the network.
●
Line Processor
, described in Chapter 6. A record must exist for every LP in
every node.
●
LAN card(s)
that will connect to any attached LAN(s). See Chapter 6.
●
Trunk
(Chapter 7) or
frame relay
(Chapter 8) port(s) that will connect to the
network and/or PVC(s).
●
SNA Port
, described on page 11-4. A record must exist for every port on every
LP in every node. Each SNA port’s record will identify the port and define its
operating parameters.
●
Subscriber ID(s)
, described on page 11-9, if SNA traffic will be transported over
the frame relay link via a logical X.25 port. This file assigns called and calling
addresses to ports, and defines alternate routing paths.
●
SDLC PUs
, described on page 11-12. If the port is an HPAD, you must specify
any TPADs with which it will communicate. If the port is a TPAD, you must
specify any remote devices with which it will communicate.
●
LLC2 hosts
(page 11-19) and
interfaces
(page 11-25), if the SDLC device(s)
will be connected to the node via a LAN, or if SDLC will be transported over
frame relay per RFC 1490.
●
Virtual LAN ID
(page 11-19) – since an FRX8000 is seen to LLC2 as a virtual
LAN, an ID must be specified to identify the node to LLC2.
Summary of Contents for Netlink FRX8000
