Cabletron Systems Netlink FRX8000, User Manual

Page: 157 / 468

Configuring SNA 11-9
LPDA Support
specifies the version (if any) of Link Problem Determination Aid that can be used by
a host program (e.g., VTAM) or controller program (e.g., NCP) to test status and to
control the line and remote interface.
Configurable values are:
0
= None
1
= Version 1
2
= Version 2
Idle Fill Character
specifies a character that will be inserted into the stream when the SNA link is idle.
Configuring Subscriber IDs
This operation configures the called and calling addresses that will be used in X.25
call setup if SNA is being transported over the frame relay link via a logical X.25 port.
To complete the connection, the software must recognize where the call is coming
from (calling address) and where it is going (called address).
To configure an SVC Subscriber record, press
[A]
, then
[C]
at the Subscriber Config-
uration Menu (or
[A], [F], [A], [C]
from the Main Menu). When prompted, enter a
Sub-
scriber ID
, up to 15 digits (as described on page 9-15 ). (The default is an asterisk,
which is a universal wildcard.) If this is an existing record, a screen similar to Figure
11-4 will be displayed. If this is a new record, enter the remaining requested infor-
mation, noting the values in
Table 11-5 .
Figure 11-4 SVC Subscriber Record
[A],[F],[A],[C] from Main Menu
The parameters displayed by pressing
[1]
or
[2]
are listed in Table 11-5.
Su bscrib er Maintenance
* S ubs criber ID 10000100001
A S ubs criber Name ssu b1
B D ialup Su bscrib er N
C R outing A lgorithm 0 R ound Rob in
D S ystematic R ed irection Y
E R ed irect on Busy N
F R ed irect on Ou t of Order N
G Ban dw. A llocation Grou p 1
1 R outing Paths
2 R ed irection Add ress es
Select: