Cabletron Systems Netlink FRX8000, User Manual

Page: 185 / 468

Configuring BSC 12-9
Subscriber Parameters
Subscriber Name
identifies the subscriber to the console operator. The FRX8000 software does not use
this information.
Routing Algorithm
allows creation of a “hunt group” of ports, for the purpose of routing per a pre-selected
algorithm:
0 = Round Robin – selects ports specified cyclically in numerical order according
to the list of Routing Paths. If the selected port is unreachable or congested, the
Call Request will be sent to the next port. (If the port becomes available again, it
is included in its assigned position.)
1 = Route if Line Failed – selects the first port that is not in a failed state. If the
selected port does not make a connection, the call is cleared, even if other ports
are available.
2 = Route if Line Busy – selects the first port that has LCNs available (is not
busy). If the port has failed, the next available port is selected.
If use of a routing algorithm is not desired, simply accept the default, and specify only
one routing path.
Systematic Redirection
redirects all calls to the alternate subscribers specified by the Redirection Addresses.
Consecutive attempts at call redirection are made to each alternate subscriber in order
of the index numbers, until the call is completed.
Redirect on Busy
redirects calls according to the Redirection Addresses if the primary subscriber device
is busy.
Redirect on Out of Order
redirects calls according to the Redirection Addresses if the primary subscriber device
is out of order.
Table 12-2 Subscriber Parameter
Parameter Valid Values Default Value
Subscriber Name
0–24 characters none
Di alup Subscriber n/a on SNA ports N
Routing Algorithm 0–2 0
Systematic Redirection Y/ N N
Redirect on Busy Y/ N N
Redirect on Out of O rder Y/ N N
Bandw. Al loc. Group 1–3 1
1st/2nd/etc. Routing Path
valid node/LP/port
Not used
1st/2nd/etc. Redirected Sub No. valid address Not used