Cabletron Systems Netlink FRX8000, User Manual

Page: 202 / 468

13-12 FRX8000 3. 0 User G uide, Rev 02
1
If configuring a line speed of 38.4K bps or higher,
RTS-CTS H/W Flow Control
must be
set to
Y
.
2
Default Window Size
in Network Defaults file.
3
Default Packet Size
in Network Defaults file or
256
, whichever is smaller.
4
0
means the timer is disabled.
Physical Interface
is the hardware interface. On an AST LP, this is always RS-232. On an RLP, the
interface is determined by the associated Line Interface Card (LIC) and the cable
attached to the port's I/O box connector. The LP record identifies the LIC, and only
the valid interfaces will be displayed as choices in the Port record.
Parity 0–3 0
DCE Cable Attached Y/N N
Mask Link Alar ms Y/N N
Disable X.121 User Call s Y/N N
PVC? Y/N N
X.25 Parameters
Defaul t Window Size 1–7
see note
2
Defaul t Packet Si ze 16–256
see note 3
Local Charging Prevention Y/N N
Generate M-bit Packets Y/N N
Defaul t Calling Address
0–15 digits none
Autocall Options
Autocall Y/N N
Autocall Delay
(sec)
0–255 0
Cal led Address
valid subscriber ID none
Retry Count 0–10 5
Retry Interval
(sec)
0–255 60
User Data
(ASCII) 0–12 characters none
Facilities
(hex) 0–28 hex characters none
Modem Signal Options
RTS-CTS H/W Flow Control Y/N
1
N
DTR/RTS Active when VC Up Y/N N
Input Signal Detection 0–5 1
Disconnect Options
Disconnect Ti mer
(min)
0–60
4
2
Disconnect Durati on
(sec)
0–300 0
Timeout i f no Login Y/N N
Timeout i f no Call Y/N N
Timeout i f no Data Y/N N
Disconnect i f Cl ear Recvd Y/N N
Disconnect i f Cl ear Sent Y/N N
Table 13-3 Async PAD Port Parameters
Parameter Valid Values Default Value
(contd.)