Cabletron Systems Netlink FRX8000, User Manual

Page: 347 / 468

Alarms 21-25
b714
– during the link layer–to–PL message Main routine
(pl_lldata()), the facility was LPRSDM (Reset Slowdown Mode).
b715
– during the link layer–to–PL message Main routine
(pl_lldata()), the facility was LPSSDM (Set Slowdown Mode) and
the VC ID was invalid.
b716
– during the link layer–to–PL message Main routine
(pl_lldata()), the facility was LPRSET (Received SNRM for FRMR
reset by secondary; will send QSNRM to RSAP) the VC ID was
invalid.
b717
– during the link layer–to–PL message Main routine
(pl_lldata()) if the VC ID was invalid.
b718
– during the PL Main routine, the VC ID was invalid; this is
followed by another error containing the message VC ID.
ba01
– the link level data–to–level 3 routine (spfldtl3()) was called
and the data was lost.
ba02
– the Log Error Message routine (x_logerr()) was called from
the NPAD Finite State Machine module.
ba03
– the Trap Action routine (xllc_trap()) was called from the
NPAD Finite State Machine module.
bb01
– the spxllc_main() routine (called to receive all XPAD
messages) was called with an invalid port type.
bb02
– the spxllc_main() routine (called to receive all XPAD
messages) was called with a message type of NETFRM (received
frame from the driver) and the frame was more than the maximum
data size supported (12data_size).
bb03
– the spxllc_main() routine (called to receive all XPAD
messages) was called with an Unknown Message Type.
bb04
– the spll_ctlmsg() routine was called with an Unknown
Facility.
bb07
– the spll_pktmsg() routine (received message from the packet
layer) was called with an Unknown Facility.
bb08
– the spll_linkch() routine was called with an Unknown
Level 1 State.
bc01
– the SPLLC Main routine (spllcmr()) received a message with
a bad port type.
bd01
– the Acknowledge Queue exceeded the window. (Generated
from the Common Flow Chart Action routine of the SDLC
Secondary module (sps_ac91()).
bd02
– the Trap Action routine (sllc_trap()) of the SDLC Secondary
module was called.
be01
– the SDLC Main routine received a message of type
WACKOUT (no piggyback acknowledged)
be04
– the SNA exchange received an unknown message. This error
should be immediately followed by another event 147, containing
what is probably the correct error code.