Cabletron Systems Netlink FRX8000, User Manual

Page: 351 / 468

Alarms 21-29
Action: Back up the accounting file, then delete it, as described in
Chapter 18 .
187.
Enable autocall on Node “n” LP “n” Port “n” SNA PAD initiated.
Severity: 4
Meaning: Self-explanatory.
188.
Upgrade in Progress is set but node “n” is an FRX8000.
Severity: 3
Meaning: The parameter
Upgrade in Progress
(see page E-5) is used while the
network is being upgraded to N7000 Release 5.0 from an earlier
release. After all nodes are at 5.0, the parameter must be set to
N
;
otherwise, this alarm will be generated whenever the software
senses an FRX8000 node in the network.
Action: Set
Upgrade in Progress
to
N
.
189.
LP “n” Port “n” Duplicate Terminal “n” from (Subscriber ID)
Severity: 3
Meaning: The TPAD has supplied, in its list of terminal addresses, a terminal
address that has already been received by the HPAD. The HPAD
discards duplicate terminal addresses.
Action: Determine which port has the duplicate terminal address and recon-
figure the terminal address in the Port record.
190
. LP “n” Port “n” Excess Terminal “n” from (Subscriber ID)
Severity: 3
Meaning: The TPAD has supplied more than 32 terminal addresses to this
HPAD. All terminal addresses in excess of 32 are discarded.
Action: Determine which port(s) has the excess terminal address(es) and
reconfigure the terminal(s) to a different HPAD (remote subscriber)
in the Port record.
194.
LP “n” Port “n” enabled
Severity: 4
Meaning: Self-explanatory.
195.
X25 LP “n”, Port “n” received Node command “n,” state was “n”
Severity: 4
Meaning: This is used as an LP diagnostic aid. When a diagnostic flag is
turned on, this message appears when the LP Frame Processor task
processes disc, reset, enable, or disable messages from the PPM.
196.
X25 LP “n” Port “n” Sent state change indication “n”
Severity: 4