Texas Instruments RM48 series, Technical Reference Manual

Page: 852 / 1759

N2HET Control Registers
www.ti.com
852 SPNU503C – March 2018
Submit Documentation Feedback
Copyright © 2018, Texas Instruments Incorporated
High-End Timer (N2HET) Module
20.4.1 Global Configuration Register (HETGCR)
N2HET1: offset = FFF7 B800h; N2HET2: offset = FFF7 B900h
Figure 20-56. Global Configuration Register (HETGCR) [offset = 00h]
31 25 24
Reserved HET_PIN_ENA
R-0 R/W-1
23 22 21 20 19 18 17 16
Reserved MP Reserved PPF IS CMS
R-0 R/W-0 R-0 R/W-0 R/W-0 R/W-0
15 1 0
Reserved TO
R-0 R/W-0
LEGEND: R/W = Read/Write; R = Read only; - n = value after reset
Table 20-16. Global Configuration Register (HETGCR) Field Descriptions
Bit Field Value Description
31-25 Reserved 0 Reads return 0. Writes have no effect.
24 HET_PIN_ENA Enables the output buffers of the pin structures depending on the value of nDIS and DIR.x when
PINDIS.x is set.
Note: This bit will automatically get cleared when nDIS pin (input port) value is 0.
0 No affect on the pin output buffer structure.
1 Enables the pin output buffer structure when DIR = output, PINDIS.x is set and nDIS = 1.
23 Reserved 0 Reads return 0. Writes have no effect.
22-21 MP Master Priority
The NHET can prioritize master accesses to N2HET RAM between the HET Transfer Unit and
another arbiter, which outputs the access of one of the remaining masters. The MP bits allow the
following selections:
0 The HTU has lower priority to access the N2HET RAM than the arbiter output.
1h The HTU has higher priority to access the N2HET RAM than the arbiter output.
2h The HTU and the arbiter output use a round robin scheme to access the N2HET RAM.
3h Reserved
20-19 Reserved 0 Reads return 0. Writes have no effect.
18 PPF Protect Program Fields
The PPF bit together with the Turn On/Off bit (TO) allows to protect the program fields of all
instructions in N2HET RAM.
When TO = 0:
0 All masters can read and write the program fields.
1 All masters can read and write the program fields.
When TO = 1:
0 All masters can read and write the program fields.
1 The program fields are readable but not writable for all masters, which could access the N2HET
RAM. Possible masters are the CPU, HTU, DMA and a secondary CPU (if available). Writes
initiated by these masters are discarded.
17 IS Ignore Suspend
When Ignore Suspend = 0, the timer operation is stopped on suspend (the current timer instruction
is completed). Timer RAM can be freely accessed during suspend. When set to 1, the suspend is
ignored and the N2HET continues operating.
0 N2HET stops when in suspend mode.
1 N2HET ignores suspend mode and continues operation.