Remote control commands
R&S
®
RTO6
1654
User Manual 1801.6687.02 ─ 05
EXPort:WAVeform:DLOGging
<DataLogging>
The command enables the export of subsequent acquisitions of the selected wave-
forms. The waveforms are taken from a running Nx Single acquisition (data logging,
history is disabled), or from the history (multiple waveforms, history is enabled).
CHANnel<m>[:WAVeform<n>]:HISTory[:STATe]
) and
data logging is enabled, a specified number of waveforms is transferred to file directly
during RUN Nx SINGLE acquisition. Enabling data logging stops a running acquisition.
Set the number of acquisitions to be acquired and stored with
and
.
If the history is enabled, the subsequent waveforms are taken from the history. Specify
the range with
CHANnel<m>[:WAVeform<n>]:HISTory:STARt
CHANnel<m>[:WAVeform<n>]:HISTory:STOP
. Then play the history with
CHANnel<m>[:WAVeform<n>]:HISTory:PLAY
.
The commands
CHANnel<m>[:WAVeform<n>]:DATA[:
CHANnel<m>[:WAVeform<n>]:DATA:HEADer?
data logging is enabled. The
command disables data logging.
If data logging is off, and the history is enabled, one waveform out of the history is writ-
ten to file. Specify the waveform using
CHANnel<m>[:WAVeform<n>]:HISTory:
.
Parameters:
<DataLogging>
ON | OFF
*RST:
OFF
Example:
See:
"Exporting multiple running acquisitions of a single waveform to
XML file"
"Exporting multiple acquisition of the history to XML file"
"Exporting a single acquisition of the history to BIN file"
Usage:
Asynchronous command
EXPort:WAVeform:TIMestamps
<UseTimestamps>
Exports the relative timestamps of all history waveforms to the waveform data file. The
time is written at the beginning of each waveform record.
Parameters:
<UseTimestamps>
ON | OFF
*RST:
OFF
Usage:
Asynchronous command
Data management