R&S RTO6, User Manual

Page: 628 / 2677

Protocol analysis
R&S
®
RTO6
628 User Manual 1801.6687.02 ─ 05
"Data (min/
max)" Enter the bytes in msb first bit order. The maximum pattern length is 8
bytes.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor" , on page 493.
Remote command:
TRIGger<m>:FLXRay:DCONdition
on page 1876
TRIGger<m>:FLXRay:DMIN
on page 1876
TRIGger<m>:FLXRay:DMAX
on page 1876
Symbol
Triggers on a symbol or on a wakeup pattern.
Trigger type: "Symbol"
"CAS/MTS" Collision Avoidance Symbol / Media access Test Symbol. These sym-
bols are identical and can be sent in the optional symbol window at
the end of a communication cycle. They are used to avoid collisions
during the system start.
"Wakeup Pat-
tern" The wakeup pattern is sent to activate the nodes of the system.
Remote command:
TRIGger<m>:FLXRay:SYMBol
on page 1877
Error conditions
Triggers on one or more errors in the frame.
Trigger type: "Error conditions"
"FSS" Error in a Frame Start Sequence. FSS follows the Transmission Start
Sequence TSS at the beginning of each frame.
"BSS" Error in a Byte Start Sequence. The BSS is transmitted before each
byte.
"FES" Error in Frame End Sequence. FES indicates the end of each frame.
"Header CRC" Error in a cyclic redundancy check code of the header data which
covers mainly frame ID and payload length.
"Payload CRC" Error in a cyclic redundancy check code of the complete frame.
Remote command:
TRIGger<m>:FLXRay:FSSerror
on page 1877
TRIGger<m>:FLXRay:BSSerror
on page 1877
TRIGger<m>:FLXRay:FESerror
on page 1877
TRIGger<m>:FLXRay:HCRCerror
on page 1878
TRIGger<m>:FLXRay:PCRCerror
on page 1878
13.9.2.2 Triggering on FlexRay signals
Prerequisites: An FlexRay bus is configured, see .
1. Press the [Bus] key and selet the "Shortcuts" tab.
FlexRay (option R&S RTO6-K520)