R&S RTO6, User Manual

Page: 580 / 2677

Protocol analysis
R&S
®
RTO6
580 User Manual 1801.6687.02 ─ 05
Figure 13-14: Configuration for CAN
See also: Chapter 13.1.1, "Setup - general settings" , on page 485
Protocol
Defines the protocol type of the selected serial bus.
Remote command:
BUS<m>:TYPE
on page 1670
Decode
Enables the decoding of the selected bus. The signal icon of the bus appears on the
signal bar.
Remote command:
BUS<m>[:STATe]
on page 1670
Data
Sets the source of the selected data line.
Usually, the source is one of the analog channels. Reference and math waveforms are
available as source if the trigger source is one of the analog channels but not the serial
bus.
Alternatively, digital channels can be used if MSO option R&S RTO6-B1 is installed.
Digital and analog channels cannot be used at the same time.
For triggering on a serial bus, analog or digital channel sources are required.
CAN and CAN FD (option R&S RTO6-K520)