Protocol analysis
R&S
®
RTO6
878
User Manual 1801.6687.02 ─ 05
Remote command:
BUS<m>:DPHY:CP:HSPeed:HYSTeresis
BUS<m>:DPHY:DPZero:HSPeed:HYSTeresis
BUS<m>:DPHY:DPONe:HSPeed:HYSTeresis
BUS<m>:DPHY:DPTWo:HSPeed:HYSTeresis
BUS<m>:DPHY:DPTHree:HSPeed:HYSTeresis
Low power thresholds ← Set thresholds
Sets the thresholds for the low-power mode.
DP0 High / DN0 High ← Low power thresholds ← Set thresholds
Sets the high-power threshold value for the respective lane.
Remote command:
BUS<m>:DPHY:DNZero:LPOWer:THUPper
BUS<m>:DPHY:DPZero:LPOWer:THUPper
DP0 Low / DN0 Low ← Low power thresholds ← Set thresholds
Sets the low-power threshold value for the respective lane.
Remote command:
BUS<m>:DPHY:DNZero:LPOWer:THLower
BUS<m>:DPHY:DPZero:LPOWer:THLower
Couple thresholds ← Set thresholds
Enables coupling, i.e. the same threshold and hysteresis value is used for all lanes.
Remote command:
13.23.2.2
Display settings
Access: [Bus] > "Configuration" tab > "Protocol = D-PHY" > "Display" tab
To enhance the decode possibilities of the D-PHY protocol, you can use an additional
setting in the "Display" tab: "Decode layer".
Access: [Bus] > "Display" tab.
For common display settings, see
Decode layer
Selects the decode layer.
Decoding is performed in several steps, and the end results are presented in the
decode table. The decode layer selects an interim step for which the decoding result is
shown in the honeycomb display.
"HS Edges"
The high-speed edges of each lane, showing the transitions in high-
speed mode.
"HS Binary"
All high-speed bits of each lane, whether they are part of a burst or
not.
D-PHY (option R&S
RTO6-K580)