R&S RTO6, User Manual

Page: 299 / 2677

Measurements
R&S
®
RTO6
299 User Manual 1801.6687.02 ─ 05
9. To compile and display statistics for the measurement, enable "Statistics". See also
Chapter 8.2.12.1, "Statistics" , on page 356.
10. Optionally, perform a limit or margin check as described in Chapter 8.2.13.1, "Per-
forming limit checks" , on page 364.
11. "Enable" the measurement group.
The measurement results are displayed by default below the waveform diagram.
8.2.1.3 General measurement settings
Automatic measurements are configured in the "Measurements" dialog box.
Access: [Measure] > "Setup" tab
This section describes the settings that relate to all measurements. Specific settings
are described in the corresponding category chapters:
●
Chapter 8.2.5.2, "Settings for amplitude/time measurements" , on page 321
●
Chapter 18.1, "Jitter measurements (options R&S RTO6-K12/K13)" , on page 1069
●
Chapter 8.2.6.2, "Settings for eye diagram measurements" , on page 333
●
Chapter 8.2.7.2, "Settings for spectrum measurements" , on page 336
●
Chapter 8.2.8.5, "Settings for histogram measurement" , on page 346
MG 1/2/3/4/5/6/7/8/Quick Meas
Subtabs for each measurement group, and for the quick measurement. The subtabs
contain the configuration settings. A green dot on the tab indicates that the measure-
ment group is active.
Automatic measurements