R&S RTO6, User Manual

Page: 695 / 2677

Protocol analysis
R&S
®
RTO6
695 User Manual 1801.6687.02 ─ 05
Remote command:
TRIGger<m>:MILStd:DATA:ICONdition
on page 1966
TRIGger<m>:MILStd:DATA:IMAX
on page 1966
TRIGger<m>:MILStd:DATA:IMIN
on page 1966
11-Bit Information
The 11-Bit information sets bits 9 to 19 if there is a command or status word. The 11-Bit
information consists of the condition and one or two 11-Bit information patterns.
In binary format, use the following characters: 1; 0; or X (do not care). To enter the pat-
tern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor" ,
on page 493.
"Condition" Sets the comparison condition to a specific value or a range.
"Info Min/Info" Specifies the value or sets the start value of a range.
"Info Max"
Sets the maximum value of a range for "Condition" = "In range"/"Out
of range".
Remote command:
TRIGger<m>:MILStd:CDST:ICONdition
on page 1964
TRIGger<m>:MILStd:CDST:IMAX
on page 1965
TRIGger<m>:MILStd:CDST:IMIN
on page 1965
Subaddress/ Mode
The subaddress/mode setup consists of the condition and one or two subaddress/
mode patterns.
In binary format, use the following characters: 1; 0; or X (do not care). To enter the pat-
tern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor" ,
on page 493.
"Condition" Sets the comparison condition to a specific value or a range.
"Subaddress Min / Subaddress/Mode"
Specifies the value or sets the start value of a range.
"Subaddress
Max" Sets the maximum value of a range for "Condition" = "In range"/"Out
of range".
Remote command:
TRIGger<m>:MILStd:CMD:SCONdition
on page 1963
TRIGger<m>:MILStd:CMD:SMAX
on page 1963
TRIGger<m>:MILStd:CMD:SMIN
on page 1964
Data Word Count/Mode Code
The data word count/ mode code setup consists of the condition and one or two pat-
terns.
In binary format, use the following characters: 1; 0; or X (do not care). To enter the pat-
tern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor" ,
on page 493.
"Condition" Sets the comparison condition to a specific value or a range.
"Word Count Min/ Count Code"
Specifies the value or sets the start value of a range.
MIL-1553 (option R&S RTO6-K530)