R&S RTO6, User Manual

Page: 906 / 2677

Protocol analysis
R&S
®
RTO6
906 User Manual 1801.6687.02 ─ 05
"Data Min/Data"
Defines the bit pattern of the credit pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor" , on page 493.
"Data Max" The second credit pattern is required to specify a range with condi-
tions "In range" and "Out of range".
Remote command:
TRIGger<m>:MPHY:CREDit:CONDition
on page 2288
TRIGger<m>:MPHY:CREDit:MIN
on page 2289
TRIGger<m>:MPHY:CREDit:MAX
on page 2289
PACP Begin
Sets the specified PACP Begin to be triggered on. The PACP Begin setup consists of
the condition and one or two PACP Begin patterns.
"Condition" Defines the operator to set a specific PACP Begin, e.g. "Equal" or
"Not Equal" or a range.
"Data Min/Data"
Defines the bit pattern of the data value pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor" , on page 493.
"Data Max" The second PACP Begin pattern is required to specify a range with
conditions "In range" and "Out of range".
Remote command:
TRIGger<m>:MPHY:PBEGin:CONDition
on page 2289
TRIGger<m>:MPHY:PBEGin:MIN
on page 2289
TRIGger<m>:MPHY:PBEGin:MAX
on page 2290
PACP Function ID
Sets the specified PACP Function ID to be triggered on. The PACP Function ID setup
consists of the condition and one or two PACP Function ID patterns.
"Condition" Defines the operator to set a specific PACP Function ID, e.g. "Equal"
or "Not Equal" or a range.
"Data Min/Data"
Defines the bit pattern of the PACP Function ID pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor" , on page 493.
"Data Max" The second PACP Function ID pattern is required to specify a range
with conditions "In range" and "Out of range".
Remote command:
TRIGger<m>:MPHY:PFID:CONDition
on page 2290
TRIGger<m>:MPHY:PFID:MIN
on page 2290
TRIGger<m>:MPHY:PFID:MAX
on page 2291
M-PHY and USB SSIC (option R&S RTO6-K580 and K570)