R&S RTO6, User Manual

Page: 2290 / 2677

Remote control commands
R&S
®
RTO6
2290 User Manual 1801.6687.02 ─ 05
Suffix:
<m>
.
1..3
Parameters:
<PACPBEGINMin> Numeric or string pattern, see Chapter 24.4.6, "Bit pattern
parameter" , on page 1286. The string parameter accepts the bit
value X (don't care).
TRIGger<m>:MPHY:PBEGin:MAX <PACPBEGINMax>
Sets the end value of the PACP Begin range if
TRIGger<m>:MPHY:PBEGin:
CONDition
is set to
INRange
or
OORange
.
Suffix:
<m>
.
1..3
Parameters:
<PACPBEGINMax> Numeric or string pattern, see Chapter 24.4.6, "Bit pattern
parameter" , on page 1286. The string parameter accepts the bit
value X (don't care).
TRIGger<m>:MPHY:PFID:CONDition <CondPACPFunc>
Sets the condition for PACP Function ID. You can define an exact value or a value
range.
Suffix:
<m>
.
1..3
Parameters:
<CondPACPFunc> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding
TRIGger<m>:MPHY:PFID:
MIN
command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with
TRIGger<m>:MPHY:PFID:MIN
and
TRIGger<m>:MPHY:PFID:MAX
.
*RST: EQUal
TRIGger<m>:MPHY:PFID:MIN <PACPFunIDMin>
Specifies the PACP Function ID bit pattern, or sets the start value of a pattern range.
Suffix:
<m>
.
1..3
Protocols