R&S RTO6, User Manual

Page: 290 / 2677

Measurements
R&S
®
RTO6
290 User Manual 1801.6687.02 ─ 05
Cursor On/Off
Enables the selected cursor measurement.
Remote command:
CURSor<m>:STATe
on page 1469
Type
Defines the cursor type to be used for the measurement.
●
Horizontal cursors (Y-cursors)
Horizontal cursors are positioned automatically along the waveform and can be
adjusted manually
●
Vertical cursors (X-cursors)
Both vertical cursor lines are set automatically to the trigger position, and you can
reposition them manually.
●
Both vertical and horizontal cursors (X&Y-cursors)
Horizontal cursors are positioned automatically along the waveform and vertical
cursors are set to the trigger position. You can reposition all cursor lines manually.
Remote command:
CURSor<m>:FUNCtion
on page 1469
Source
Defines the source of the cursor measurement. Any of the input signal, math, reference
or XY waveforms can be selected.
Remote command:
CURSor<m>:SOURce
on page 1470
Second source, Source 2
Enables and selects a second source for the cursor measurements. If enabled, the
second cursor lines Cx.2 measure on the second source. Using a second source, you
can measure differences between two channels with cursors.
Remote command:
CURSor<m>:USSource
on page 1471
CURSor<m>:SSOurce
on page 1470
X1 position, X2 position
Defines the position of the vertical cursors.
Remote command:
CURSor<m>:X1Position
on page 1472
CURSor<m>:X2Position
on page 1472
Y1 position, Y2 position
Defines the position of the horizontal cursor lines. The setting corresponds to the V1
and V2 values in the "Cursor Results" box.
If "Track waveform" is enabled, the user setting is disabled and the measurement
results are displayed in the "Cursor Results" box.
Remote command:
CURSor<m>:Y1Position
on page 1473
CURSor<m>:Y2Position
on page 1473
Cursor measurements