R&S RTO6, User Manual

Page: 395 / 2677

Mask testing
R&S
®
RTO6
395 User Manual 1801.6687.02 ─ 05
Acq. completed
Number of tested acquisitions.
Remote command:
MTESt:RESult:COUNt:WAVeforms?
on page 1597
Acq. remaining
Remaining acquisitions until "Average count / Nx Single count" is reached.
The value is useful if you test a specified number of acquisitions with action "Stop
acquisition" on violation. Also if the acquisition has been stopped manually before the
required number of acquisitions has been acquired.
Remote command:
MTESt:RESult:COUNt:REMaining?
on page 1598
State
Shows if the test has been completed. The state is set to "Finished" when "Nx Single
count" acquisitions are tested and the number of "Acq. remaining" is 0. as long as the
number of tested acquisitions is less the "Nx Single count" number, the state is "Run-
ning".
If you run the acquisition with [Run Stop], or the number of played history acquisitions
exceeds "Nx Single count", the mask testing is performed according to fail criteria set-
tings independently of the test state. The testing is not stopped when the state is set to
"Finished".
Remote command:
MTESt:RESult:STATe?
on page 1597
Sample hits
Number of samples that hit the mask.
Remote command:
MTESt:RESult:COUNt:FAILures?
on page 1598
Acquisition hits
Number of acquisitions that contained at least one sample hit.
Remote command:
MTESt:RESult:COUNt:FWAVeforms?
on page 1598
Fail rate
Ratio of acquisition hits to the number of tested acquisitions.
Remote command:
MTESt:RESult:FRATe?
on page 1599
About mask testing