Getting started
R&S
®
RTO6
29
User Manual 1801.6687.02 ─ 05
●
1. Ensure that the monitors and the R&S
RTO6 are connected to a ground contact.
Otherwise the instrument can be damaged.
2. Check the input type of the monitors. Make sure to select the correct cable. If the
connectors do not match, use an appropriate adapter.
3. You can configure the displays directly in the instrument's setup. Open "Menu" >
"Settings" > "Display".
4. Select the "Monitors" tab.
5. Select how to display the screen. Select "Extend" to arrange dialogs and result
boxes on different displays.
6. To move the main firmware window to an external monitor, press F11 on the key-
board.
Now the firmware shows a soft frontpanel together with the usual display in a win-
dow. You can move this window to an external monitor.
7. To access Windows display settings, tap "Additional settings".
The touchscreen of the R&S
RTO6 has a screen resolution of 1920x1080 pixels pixel.
Many external monitors have a higher screen resolution. If the screen resolution of the
monitor is set higher than the instrument's resolution, the firmware window uses a
1920x1080 pixels area of the monitor display. For full screen display, adjust the moni-
tor's screen resolution using "Additional display settings".
3.2
Instrument tour
This chapter describes the front and rear panels of the instrument including all function
keys and connectors.
3.2.1
Front panel
The front panel of the R&S
RTO6 is shown in
. The function keys are grou-
ped in functional blocks to the right of the touchscreen. Below the screen, various con-
nectors are located.
Instrument tour
