R&S RTO6, User Manual

Page: 2349 / 2677

Remote control commands
R&S
®
RTO6
2349 User Manual 1801.6687.02 ─ 05
Parameters:
<ThresholdL3High> Range: -5 to 5
Increment: 1E-3
*RST:
0.02
Default unit: V
BUS<m>:PCIE:LZER:THRLow <ThresholdL0Low>
BUS<m>:PCIE:LONE:THRLow <ThresholdL1Low>
BUS<m>:PCIE:LTWO:THRLow <ThresholdL2Low>
BUS<m>:PCIE:LTHRee:THRLow <ThresholdL3Low>
BUS<m>:PCIE:SMLanes <Active>
Enables the display of the result in multiple lanes.
Suffix:
<m>
.
1..4
Parameters:
<Active> ON | OFF
*RST:
ON
24.17.27.2 Clock data recovery
BUS<m>:CDR:BITRate
................................................................................................ 2349
BUS<m>:CDR:PLL:BWIDth
.......................................................................................... 2349
BUS<m>:CDR:PLL:DAMPing
........................................................................................2350
BUS<m>:CDR:PLL:ORDer
............................................................................................2350
BUS<m>:CDR:PLL:RELBwidth
......................................................................................2350
BUS<m>:CDR:RESults
.................................................................................................2350
BUS<m>:CDR:SYNC
................................................................................................... 2351
BUS<m>:CDR:BITRate <Bitrate>
Sets the quiescent frequency of the PLL. It corresponds to the data rate of the data
stream from which the clock is to be recovered.
Suffix:
<m>
.
1..4
Parameters:
<Bitrate> Range: 100 to 5E+9
Increment: 10
*RST:
1E+9
Default unit: bps
BUS<m>:CDR:PLL:BWIDth <PLLBandwidth>
Sets the PLL bandwidth. It defines the part of the spectrum that the PLL can follow dur-
ing synchronization. The PLL bandwidth is usually defined by the transmission stan-
dard.
Protocols