R&S RTO6, User Manual

Page: 166 / 2677

Acquisition and waveform setup
R&S
®
RTO6
166 User Manual 1801.6687.02 ─ 05
Figure 5-16: Probe setup for current probes R&S RT-ZC20B
For all current probes, attenuation or gain is shown in the "Setup" tab, and you can set
the offset to mean:
●
"Probe unit, Auto attenuation" on page 148
●
"Offset to mean" on page 164
Current probes R&S RT-ZCxxB are adjusted by the following functions:
DeGauss ..................................................................................................................... 166
Detect AutoZero .......................................................................................................... 167
Zero adjust .................................................................................................................. 167
Save to probe ..............................................................................................................167
DeGauss
Demagnetizes the core if it has been magnetized by switching the power on and off, or
by an excessive input. Always carry out demagnetizing before measurement.
The demagnetizing process takes about one second. During demagnetizing, a demag-
netizing waveform is displayed.
Demagnetizing is done automatically when R&S RT-ZCxxB is connected to the oscillo-
scope, or when "Detect AutoZero" is performed.
Remote command:
PROBe<m>:SETup:DEGauss
on page 1362
Probes