R&S RTO6, User Manual

Page: 677 / 2677

Protocol analysis
R&S
®
RTO6
677 User Manual 1801.6687.02 ─ 05
DLC
Sets the data length code, which indicates the length of the data byte.
The DLC setup consists of the condition and one or two DLC patterns.
"Condition" Defines the operator to set a specific DLC ("Equal" or "Not equal") or
a DLC range.
"DLC min /
DLC " Defines the bit pattern of the DLC.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor" , on page 493.
"DLC max" The second DLC pattern is required to specify a range with conditions
"In range" and "Out of range".
Remote command:
TRIGger<m>:CXPI:DLC:CONDition
on page 1937
TRIGger<m>:CXPI:DLC:MAX
on page 1937
TRIGger<m>:CXPI:DLC:MIN
on page 1937
DLC Extend
Sets the extension data length code, which indicates the length of the data byte of a
long frame.
The DLC extend setup consists of the condition and one or two DLC patterns.
"Condition" Defines the operator to set a specific DLC extend ("Equal" or "Not
equal") or a DLC extend range.
"DLC Extend
min / DLC
Extend" Defines the bit pattern of the DLC extend.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor" , on page 493.
"DLC Extend
max" The second DLC extend pattern is required to specify a range with
conditions "In range" and "Out of range".
Remote command:
TRIGger<m>:CXPI:DEXTension:CONDition
on page 1936
TRIGger<m>:CXPI:DEXTension:MAX
on page 1936
TRIGger<m>:CXPI:DEXTension:MIN
on page 1936
Data
The data setup consists of the condition and one or two identifier pattern.
"Condition" Defines the operator to set a specific data ("Equal" or "Not equal") or
a data range.
"Data min /
Data" Defines the bit pattern of the data.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor" , on page 493.
"Data max" The second data pattern is required to specify a range with conditions
"In range" and "Out of range".
CXPI (option R&S RTO6-K520)