Chapter 6: Using the Web Interface
308
Configuring the Serial Port
You can change the bit rate of the serial port labeled CONSOLE / MODEM
on the SRC. The default bit rate for console and modem operation is
115200 bps.
The SRC supports using the following devices via the serial interface:
A computer for console management.
A Raritan KVM product.
An analog modem for remote dial-in and access to the CLI.
A GSM modem for sending out SMS messages to a cellular phone.
Bit-rate adjustment may be necessary. Change the bit rate before
connecting the supported device to the SRC through the serial port, or
there are communication problems.
Note: The serial port bit-rate change is required when the SRC works in
conjunction with Raritan's Dominion LX KVM switch. Dominion LX only
supports 19200 bps for communications over the serial interface.
You can set diverse bit-rate settings for console and modem operations.
Usually the SRC can detect the device type, and automatically apply the
preset bit rate.
The SRC will indicate the detected device in the Port State section of the
Serial Port page.
To configure serial port and modem settings, choose Device Settings >
Serial Port.
To change the serial port's baud rate settings:
1.
Click the 'Connected device' field to make the serial port enter an
appropriate state.
Options
Description
Automatic detection
The SRC automatically detects the type of the device
connected to the serial port.
Select this option unless your SRC cannot correctly
detect the device type.
Force console
The SRC attempts to recognize that the connected
device is set for the console mode.
Force analog modem
The SRC attempts to recognize that the connected
device is an analog modem.
Force GSM modem
The SRC attempts to recognize that the connected
device is a GSM modem.
Summary of Contents for Raritan SRC-0100
