Appendix B: Configuration or Firmware Upgrade with a USB Drive
545
For example,
mac:7
instructs the SRC to search for the MAC
address in the 7th column of the "devices.csv" file.
The default value is
serial:1
, making the SRC search for its serial
number in the first column.
This option is used only if the "device_list" option has been set.
factory_reset
If this option is set to
true
, the SRC will be reset to factory defaults.
If the device configuration will be updated at the same time, the
factory reset will be executed before updating the device
configuration.
bulk_config_restore
Specify the name of the bulk configuration file used to configure or
restore the SRC.
Note: See
Bulk Configuration
(on page 330) for instructions on
generating a bulk configuration file.
Additional configuration keys set via the
config.txt file will be applied
after performing the bulk restore operation.
This option CANNOT be used with the option "full_config_restore."
If a firmware upgrade will be performed at the same time, you must
generate the bulk configuration file based on the NEW firmware
version instead of the current firmware version.
full_config_restore
Specify the name of the full configuration backup file used to restore
the SRC.
Note: See
Backup and Restore of Device Settings
(on page 335) for
instructions on generating the full configuration backup file.
Additional configuration keys set via the
config.txt file will be applied
after performing the configuration restore operation.
This option CANNOT be used with the option "bulk_config_restore."
If a firmware upgrade will be performed at the same time, you must
generate the full configuration backup file based on the NEW
firmware version instead of the current firmware version.
collect_diag
If this option is set to
true
, the diagnostic data of the SRC is
transmitted to the USB drive.
The filename of the diagnostic data written into the USB drive is:
diag_<unit-serial>.zip
Summary of Contents for Raritan SRC-0100
