LEGRAND Raritan SRC-0100, User Manual, Page: 396 / 698

Chapter 8: Using the Command Line Interface
384
Interface Description
bridge Show the IPv4 or IPv6 configuration of the BRIDGE
interface.
all Show the IPv4 or IPv6 configuration of all
interfaces.
Tip: You can also type the command without
adding this option "all" to get the same data. That
is, show network ipv4 interface.
Network Interface Settings
This command shows the specified network interface's information
which is NOT related to IP configuration. For example, the Ethernet
port's LAN interface speed and duplex mode, or the wireless interface's
SSID parameter and authentication protocol.
# show network interface <ETH>
Variables:

<ETH> is one of the network interfaces: ETH1/ETH2, WIRELESS, or
BRIDGE. Note that you must choose/configure the bridge interface if
your SRC is set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE
interface function. The IP parameters of ETH1/ETH2 and WIRELESS
interfaces do NOT function.
Interface Description
eth1 Show the ETH1 interface's non-IP settings.
eth2 Show the ETH2 interface's non-IP settings.
wireless Show the WIRELESS interface's non-IP settings.
bridge Show the BRIDGE interface's non-IP settings.
all Show the non-IP settings of all interfaces.
Tip: You can also type the command without
adding this option "all" to get the same data. That
is, show network interface.