LEGRAND Raritan SRC-0100, User Manual

Page: 34 / 698

Chapter 3: Initial Installation and Configuration
22
2. Connect a USB cable between a computer's USB-A port and the
USB-B port of SRC.
3. Perform Initial Network Configuration via CLI (on page 657).
Note: Not all serial-to-USB converters work properly with the SRC
so Raritan does not introduce the use of such converters.
Serial connection for "RJ-45" RS-232 connector:
1. Connect the RJ-45 end of the RJ45-to-DB9 adapter cable to the
RJ-45 port labeled CONSOLE / MODEM on SRCCabinet Live Chart.

See
RJ45-to-DB9 Cable Requirements for Computer
Connections
(on page 22).
2. Connect the DB9 end to your computer's RS-232 port (COM).
3. Perform Initial Network Configuration via CLI (on page 657).
RJ45-to-DB9 Cable Requirements for Computer Connections
An RJ45-to-DB9 adapter/cable is required for connecting the SRC to a
computer, if the use of a USB cable is not wanted.
A third party RJ45-to-DB9 adapter/cable needs to meet the following
requirements.

RJ-45 to "DB9 female"

RX/TX and according control pins are CROSSED
The widespread blue Cisco RJ-45 to DB9 adapter cable is highly
recommended, which has the following pin assignments:
DB9 pin signal DB9 pin No. RJ-45 pin No. RJ-45 pin signal
CTS 8 1 RTS
DSR 6 2 DTR
RxD 2 3 TxD
GND 5 4 GND
GND 5 5 GND
TxD 3 6 RxD
DTR 4 7 DSR
RTS 7 8 CTS
DCD 1 (Not connected)
RI 9 (Not connected)
N/A