LEGRAND Raritan SRC-0100, User Manual

Page: 201 / 698

Chapter 6: Using the Web Interface
189

In the Port Forwarding mode, all cascaded devices share the
master device's network settings. You only need to configure the
master device's network settings in the ETH1/ETH2 and/or
WIRELESS section.
See
Wired Network Settings
(on page 170) or
Wireless Network
Settings
(on page 177)
Tip: You can enable/configure multiple network interfaces in the Port
Forwarding mode so that the cascading chain has multiple IP
addresses.
7. Click Save.
For information on accessing each cascaded device in the Port
Forwarding mode, see
Port Forwarding Examples
(on page 193).
Enable R/STP if a cascade loop is preferred:

You can "loop" a cascading chain to create network communication
redundancy (Bridging mode only), but only when your network
supports R/STP protocol.
Make sure that your network has R/STP enabled if using a cascade
loop (Bridging mode)
or else network loops may occur.
Online cascading information:
For detailed information on the cascading configuration and restrictions,
refer to the
Cascading Guide, which is available from Raritan website's
Support page
(
).