LEGRAND Raritan SRC-0100, User Manual

Page: 426 / 698

Chapter 8: Using the Command Line Interface
414
Interface Description
bridge Determine the IPv6 preferred host name of the
BRIDGE interface (that is, bridging mode).

<name> is a host name which:

Consists of alphanumeric characters and/or hyphens

Cannot begin or end with a hyphen

Cannot contain more than 63 characters

Cannot contain punctuation marks, spaces, and other symbols
Setting the IPv6 Address
After selecting the static IP configuration mode, you can use this
command to assign a permanent IP address to the SRC.
config:# network ipv6 interface <ETH> address <ip
address>
Variables:

<ETH> is one of the network interfaces: ETH1/ETH2, WIRELESS, or
BRIDGE. Note that you must choose/configure the bridge interface if
your SRC is set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE
interface function. The IP parameters of ETH1/ETH2 and WIRELESS
interfaces do NOT function.
Interface Description
eth1 Determine the IPv6 address of the ETH1 interface
(wired networking).
eth2 Determine the IPv6 address of the ETH2 interface
(wired networking).
wireless Determine the IPv6 address of the WIRELESS
interface (that is, wireless networking).
bridge Determine the IPv6 address of the BRIDGE
interface (that is, the bridging mode).