LEGRAND Raritan SRC-0100, User Manual

Page: 386 / 698

Chapter 7: Using SNMP
374
Configuring NTP Server Settings
Using SNMP, you can change the following NTP server-related settings
in the unitConfigurationTable:

Enable or disable synchronization of the device's date and time with
NTP servers (synchronizeWithNTPServer)

Enable or disable the use of DHCP-assigned NTP servers if
synchronization with NTP servers is enabled
(useDHCPProvidedNTPServer)

Manually assign the primary NTP server if the use of DHCP-assigned
NTP servers is disabled (firstNTPServerAddressType and
firstNTPServerAddress)

Manually assign the secondary NTP server (optional)
(secondNTPServerAddressType and secondNTPServerAddress)
Tip: To specify the time zone, use the CLI or web interface instead. For
the CLI, see
Setting the Time Zone (on page 442). For the web interface,
see Setting the Date and Time (on page 233).
When using the SNMP SET command to specify or change NTP servers,
it is required that both the NTP server's address type and address be set
in the command line simultaneously.
For example, the SNMP command to change the primary NTP server's
address from IPv4 (192.168.84.84) to host name looks similar to the
following:
snmpset -v2c -c private 192.168.84.84
firstNTPServerAddressType = dns firstNTPServerAddress =
"angu.pep.com"
A Note about Enabling Thresholds
When enabling previously-disabled thresholds via SNMP, make sure you
set a correct value for all thresholds that are supposed to be enabled
prior to actually enabling them. Otherwise, you may get an error
message.