Chapter 5: Introduction to SRC Components
85
2.
Press
to turn on or off the actuator. A confirmation message
similar to the following is shown.
3.
Press
or
to select Yes or No, and then press
.
4.
Verify that the actuator status shown on the LCD display has been
changed.
Assets
If there are no Raritan asset management strips connected, the LCD
display shows the message "No asset strips connected" for the "Assets"
menu command.
After connecting asset strips, only the information of the rack units
where asset tags have been detected is shown on the LCD display.
To show asset strip information:
1.
Press
or
to select "Assets" in the Main Menu, and press
.
2.
The display shows the available asset strip, and indicates how many
rack units and tags are detected on this strip.
The number of tags includes both the tags attached to the asset
strip and those attached to the blade extension strip, if any.
3.
Press
to show this asset strip's details, including:
State - strip status.
Main Tags - number of the tags attached to the asset strip.
Blade Tags - number of the tags attached to the blade extension
strip(s), if any.
Note: The 'Blade Tags' information appears only when there are tags
detected on the connected blade extension strip.
Summary of Contents for Raritan SRC-0100
