Chapter 6: Using the Web Interface
286
Placeholder
Definition
[SMARTCARDTYPE]
The type of a smart card
[SMTPRECIPIENTS]
The list of recipients of an outgoing mail
[SMTPSERVER]
The name or IP address of an SMTP server
[SYSCONTACT]
SNMP MIB-II sysContact field
[SYSLOCATION] SNMP
MIB-II sysLocation field
[SYSNAME]
SNMP MIB-II sysName field
[TIMEREVENTID]
The id of a timer event
[TIMESTAMP]
The timestamp of the event occurrence
[UMTARGETROLE]
The target role of a user management operation
[UMTARGETUSER]
The target user of a user management operation
[USERIP]
The IP address a user connected from
[USERNAME]
The user who performed an operation
[VERSION]
The firmware version the device is upgrading to
Note: In case you need to type any square brackets "[" and "]" in the
custom message for non-placeholder words, always add a backslash in
front of the square bracket. That is, \[ or \]. Otherwise, the message sent
will not display the square brackets.
Editing or Deleting a Rule/Action
You can change the settings of an event rule, action or scheduled action,
or delete them.
Exception: Some settings of the built-in event rules or actions are not
user-configurable. Besides, you cannot delete built-in rules and actions.
See
Built-in Rules and Rule Configuration
(on page 238) or
Available
Actions
(on page 253).
To edit or delete an event rule, action or scheduled action:
1.
Choose Device Settings > Event Rules.
2.
Click the desired one in the list of rules, actions or scheduled actions.
Its setup page opens.
3.
Perform the desired action.
To modify settings, make necessary changes and then click Save.
Summary of Contents for Raritan SRC-0100
