Chapter 7: Using SNMP
372
SNMP Gets and Sets
In addition to sending notifications, the SRC is able to receive SNMP get
and set requests from third-party SNMP managers.
Get requests are used to retrieve information about the SRC, such as
the system location.
Set requests are used to configure a subset of the information, such
as the SNMP system name.
Note: The SNMP system name is the SRC device name. When you
change the SNMP system name, the device name shown in the web
interface is also changed.
The SRC does NOT support configuring IPv6-related parameters
using the SNMP set requests.
Valid objects for these requests are limited to those found in the SNMP
MIB-II System Group and the custom SRC MIB.
The SRC MIB
The SNMP MIB file is required for using your SRC with an SNMP
manager. An SNMP MIB file describes the SNMP functions.
Summary of Contents for Raritan SRC-0100
