LEGRAND Raritan SRC-0100, User Manual

Page: 65 / 698

Chapter 4: Connecting External Equipment (Optional)
53
3. Strip the insulation around 12 mm from the end of each wire of
discrete detectors/switches.
4. Fully insert each wire of both detectors/switches into each
termination point.

Plug both wires of a detector/switch into the two termination
points to the left.

Plug both wires of the other detector/switch into the two
termination points to the right.
5. Use a screwdriver with a 2.5 mm wide shaft to tighten the screws
above each termination point to secure the wires, using a torque of
0.196 N·m (2 kgf·cm).
Note: If your terminal module is separated from SRC, you must flip it
to secure the four screws.