LEGRAND Raritan SRC-0100, User Manual

Page: 553 / 698

Appendix B: Configuration or Firmware Upgrade with a USB Drive
541
4. Plug the USB drive into the USB-A port of the SRC.
5. The initial message shown on the front panel display depends on the
first task performed by the SRC.

If no firmware upgrade task will be performed, a happy smiley is
displayed after around 30 seconds.
The happy smiley looks like the following diagram and its
background color will turn green.

If the USB drive contains the firmware upgrade data, the SRC:
a. First performs the firmware upgrade, showing the upgrade
message on the front panel display.
b. Then shows the happy smiley when the firmware upgrade
completes successfully. See
Firmware Upgrade via USB
(on
page 552).
6. After the happy smiley appears, press one of the control buttons next
to the display for one second until the smiley disappears.
Tip: You can remove the USB drive and plug it into another SRC
device for performing the same task(s) once the happy smiley or the
firmware upgrade message displays.
7. Wait for several seconds until the SRC resumes normal operation,
indicated by the normal message of the display.
If nothing is shown on the display and no task is performed after
plugging the USB drive, check the log file in the USB drive.
System and USB Requirements
You must satisfy ALL of the following requirements prior to using a USB
flash drive to perform device configuration and/or firmware upgrade.
SRC system requirements:

There is at least one USB-A port available on your Raritan device.

Your SRC must run firmware version 3.5.10 or later.
Note that the SRC interpreted the USB drive's contents using the
firmware which was running when plugging the USB drive, not the
new firmware after firmware upgrade.