LEGRAND Raritan SRC-0100, User Manual

Page: 671 / 698

Appendix I: Additional SRC Information
659
b. Default password:
raritan
(or a new password if you have
changed it).
4. If prompted to change the default password, change or ignore it.

To change it, follow onscreen instructions to type your new
password.

To ignore it, simply press Enter.
5. The # prompt appears.
6. Type
config
and press Enter.
7. To configure network settings, type appropriate commands and
press Enter. Refer to the following commands list. CLI commands
are case sensitive.
8. After finishing the network settings, type
apply
to save changes. To
abort, type
cancel
.
Commands for wired networking:
The <ipvX> variable in the following commands is either ipv4 or ipv6,
depending on the type of IP protocol you are configuring.
Replace the variable <ETH> with either 'ETH1' or 'ETH2', depending
on which Ethernet port you are configuring.

General IP settings:
To set or
enable Use this command
IPv4 or IPv6
protocol
network <ipvX> interface <ETH>
enabled <option>
<option> = true, or false
IPv4
configuration
method
network ipv4 interface <ETH>
configMethod <mode>
<mode> =
dhcp (default) or static
IPv6
configuration
method
network ipv6 interface <ETH>
configMethod <mode>
<mode> =
automatic (default) or static
Preferred host
name
(optional)
network <ipvX> interface <ETH>
preferredHostName <name>
<name> = preferred host name