Chapter 3: Initial Installation and Configuration
27
Number
Device role
Slave 2
Slave 3
To cascade SRC devices via USB:
1.
Make sure all Raritan devices are running firmware version 3.3.10 or
later. Note that SRC must run 3.5.10 or later.
2.
Choose the appropriate one as the master device.
When the Port Forwarding mode over "wireless LAN" is intended,
the master device must be a Raritan product with two USB-A
ports, such as PX3, Smart Rack Controller, EMX2-888, PX3TS or
BCM2.
3.
Log in to all devices one by one and select the same cascading mode.
Bridging mode:
Set the cascading mode of all devices to Bridging.
Port Forwarding mode:
Set the cascading mode of all devices to Port Forwarding. Make
sure the cascading role and downstream interface are also set
correctly.
See
Setting the Cascading Mode
(on page 187).
4.
Connect the master device to the LAN, using a method below.
Bridging mode:
Use a standard network patch cable (CAT5e or higher).
Port Forwarding mode:
Use a standard network patch cable and/or a Raritan USB WIFI
wireless LAN adapter. For information on the Raritan USB WIFI
adapter, see
USB Wireless LAN Adapters
(on page 12).
5.
Connect the USB-A port of the master device to the USB-B port of an
additional SRC via a USB cable. This additional device is Slave 1.
6.
Connect Slave 1's USB-A port to the USB-B port of an additional SRC
via another USB cable. The second additional device is Slave 2.
7.
Repeat the same step to connect more slave devices. You can
cascade up to 15 slave devices.
8.
(Optional) Configure or change the network settings of the master
and/or slave devices as needed. See
Configuring Network Settings
(on page 169).
Bridging mode: Each cascaded device has its own network
settings.
Summary of Contents for Raritan SRC-0100
